Care And Cleaning; Removable Oven Door - Hotpoint RB734J Use And Care Manual

Care and Cleaning

(See Cleaning Guide on pages 28 and 29.)
Proper care and cleaning are
important so your range will give
you efficient and satisfactory
service. Follow these directions
carefully in caring for your range to
assure safe and proper maintenance.
Cooktop
The porcelain enamel cooktop is
sturdy but breakable if misused.
This finish is acid resistant.
However, any acid foods spilled
(such as fruit juices, tomato or
vinegar) should not be permitted
to remain on the finish.
Cleaning Under the Range
The area under the range can be
reached easily for cleaning by
removing the bottom drawer. To
remove, pull drawer out all the way,
tilt up th~ front and remove it. To
replace, insert glides at back of
drawer beyond stop on range glides.
easily. Let front of drawer down,
then push into close.

Removable Oven Door

\\
To REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
To REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place.
Note: Upper oven door on Model
Surface Uni@
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, stay-up units lift up
and lock in the up position, and
plug-in units are removable.
Caution: Be sure all controls are
turned to OFF and surface uniti
are cool before attempting to lift
or remove them.
After lifting the stay-up units or
removing plug-in units, remove the
trim rings and drip pans under the
units and clean them according to
directions in the Cleaning Guide on
pages 28 and 29. Wipe around the
edges of the surface unit openings.
Clean the area below the units.
Rinse all washed areas with a damp
cloth or sponge.
-
(on
models so equipped)
You can lift a stay-up unit upward
about 6" and it will lock in the up
position.
To reposition the sby-up unit:
Replace the drip pan and trim
ring into the recess in the cooktop.
. Put the trim ring in place over the
drip pan. The drip pan must be
under the trim ring.
. Guide the surface unit into place
so it fits evenly into the trim ring.
24
Plug-In UniG
(on models so equipped)
Plug-in units can be removed.
Lift a plug-in unit about 1" above
the trim ring—just enough to grasp
it—and you can pull it out.
Do not lift a plug-in unit more
than 1!' If you do, it may not lie
flat on the trim ring when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1" above the trim
ring can permanently damage
the receptacle.
R
R
To replace a plug-in unit:
First place the drip pan, then the
trim ring into the surface unit cavity
found on top of the cooktop so the
unit receptacle can be seen through
the opening in the pan.
Insert the terminals of the plug-in
unit through the opening in the drip
pan and into the receptacle.
Guide the surface unit into place
so it fits evenly into the trim ring.
Note: The drip pan must be under