Agri-Fab 45-03523 Owner's Manual page 9

STEP 17 - ASSEMBLE PALNUTS AND CAPS
• Assemble two palnuts onto the ends of the pivot rod by
lightly tapping them with a hammer. See figure 19.
• Place a vinyl cap onto each bag arm tube. See figure 19.
HINT: To ease assembly of the palnuts, place the bag on
its side on a hard surface. With the bottom end of the pivot
rod against the surface, tap a palnut onto the top end of the
rod. Repeat for other end of rod.
VINYL CAP
FIGURE 19
STEP 18 - ATTACH ROPE
•
Secure the rope to the center of the upper rear
hopper tube as shown in figure 20.
FIGURE 20
STEP 19 - ATTACH HOPPER BAG
•
PALNUT
FIGURE 21
9
To attach the hopper bag to the sweeper, slide the
ends of the bag arm tubes into the ends of the hitch
tubes and secure with two 1/4" x 1-3/4" clevis pins
and small hairpin cotters. See figure 21.
BAG ARM TUBE
SMALL
HAIRPIN
HITCH TUBE HITCH TUBE
COTTER
1/4" X 1-3/4"
CLEVIS PIN