Agri-Fab 45-03523 Owner's Manual page 8

STEP 14 - ATTACH BAG SIDES
• Fold the bag flaps around the lower hopper tubes and
attach to the bag bottom using the snaps. See figure
15.
SNAP
FIGURE 15
STEP 15 - ASSEMBLE SUPPORT RODS
IMPORTANT: Do not over bend the support rods during
the following step. Over bending will decrease the supporting
tension of the rods.
• Assemble the two hopper support rods as shown in
figure 16. Place the ends of the rods into the holes in
the upper and lower hopper tubes, flexing the rod just
enough to fit into the holes in the tubes.
FIGURE 16
FLAP
SUPPORT
RODS
STEP 16 - ASSEMBLE HOPPER ROD AND
BAG ARM TUBES
• If the hole in the side of the upper hopper tubes is
covered over by the bag, locate the hole by touch. It is
approximately midway along the side of the bag. Pierce
holes through the stitched bag flaps where the holes in
both hopper tubes are located. See figure 17.
FIGURE 17
• Slide the hopper bag pivot rod through the hole in an
upper hopper tube. Assemble two bag arm tubes and
onto the rod as shown in figure 18. Push the rod on
through the upper hopper tube on the opposite side of
the bag.
FIGURE 18
8
UPPER HOPPER TUBE
PIVOT ROD
BAG ARM TUBE