Agri-Fab 45-03523 Owner's Manual page 6

STEP 10 - ASSEMBLE HEIGHT ADJUSTMENT
PIN
•
Place the height adjustment pin into the height adjust
bracket. Assemble coil spring and 3/8" washer onto
the height adjustment pin and then secure them using
a 1/8" x 3/4" cotter pin. See figure 7.
COTTER PIN
HEIGHT
ADJUSTMENT
PIN
COIL SPRING
FIGURE 7
1/8" x 3/4"
3/8" WASHER
ASSEMBLY OF HOPPER BAG
STEP 11 - ASSEMBLE UPPER TUBES
•
Insert the left hand upper hopper tube through the
stitched flaps of the hopper bag, starting at the center
cut out in the top of the bag. See figures 8, 9 and 10.
Repeat for the right hand upper hopper tube.
CENTER CUT OUT
(START HERE)
Right Left
FIGURE 8
• Slide the two upper hopper tubes together and line up
the center holes as shown in figure 9.
FIGURE 9
• Fasten the upper hopper tubes together using a
plastic plug. See figure 10.
NOTE: Plastic plug may break in later steps. It is only
used to hold tubes in place a short time and does not
need to be replaced.
FIGURE 10
6
UPPER HOPPER TUBE
(LEFT HAND SHOWN)
BAG FLAP
END HERE
UPPER HOPPER TUBES
PLASTIC PLUG