Agri-Fab 45-03523 Owner's Manual page 7

STEP 12 - ASSEMBLE LOWER TUBES
• Assemble the two lower hopper tube together using a
plastic plug. See figure 11.
NOTE: Plastic plug may break in later steps. It is only
used to hold tubes in place a short time and does not
need to be replaced.
PLASTIC PLUG
LOWER
HOPPER
TUBE
FIGURE 11
• Place the assembled lower hopper tubes into the
bottom of the hopper bag and then slide the tubes to
the back of the bag. See figure 12.
• Attach the ends of the lower hopper tubes to the
inside of the upper hopper tubes using two 3/8" x
1/2" clevis pins inserted from the inside, and two
small hair cotter pins. See figure 12.
LOWER HOPPER TUBE
FIGURE 12
UPPER HOPPER
TUBE
SMALL HAIR
COTTER PIN
3/8" x 1/2"
CLEVIS PIN
HOPPER BAG
BOTTOM
STEP 13 - ATTACH BAG BOTTOM
• Assemble the bag retainer and the bag frame strap
to the front edge of the bag bottom. Place the bag
retainer on top and the bag frame strap underneath
the bag bottom. Fasten together using six #10 x 5/8"
screws and #10-32 nylock nuts. See figure 13.
FRONT EDGE OF BAG BOTTOM
#10-32 x 5/8" SCREW
BAG RETAINER
FIGURE 13
• Assemble the bag frame strap to the holes in the
lower hopper tubes using two 1/4" x 1-1/8" clevis pins
and small hair cotter pins. See figure 14.
BAG FRAME STRAP
1/4" x 1-1/8"
CLEVIS PIN (N)
FIGURE 14
7
FRAME STRAP
#10-32
NYLOCK NUT
SMALL HAIR
COTTER PIN