Table of Contents
Advertisement
Description of unit / Starting operation
3.4
technIcal data
Voltage:
Fuse protection:
Voltage on multifunction
switch:
Unit connection line:
Socket on unit:
Max. connection:
Type of protection:
Capacity:
Max. operating pressure:
Max. volume flow:
Volume flow at 120 bar
(12 MPa) with water:
Max. size of tip:
Max. temperature of the
coating material:
Max. viscosity:
Net weight:
Hydraulic filling quanitity:
Max. tyre pressure:
Max. acoustic pressure
level:
*Place of measuring: 1 m in distance from the unit and 1.6 m
above the floor, 120 bar (12 MPa) operating pressure, reverber-
ant floor
3.5
tranSport
Push or pull unit.
Loosen terminal sleeves (fig. 5, item 1) on the shaft ( open).
Extract shaft to the desired length.
Tighten terminal sleeves again by hand ( closed).
30
Super Finish
Super Finish
27
31
230 Volt~,50 Hz
16 A slow-blow
24 V
6 m long, 3 x 1.5 mm
230 Volt ~,50 Hz
1000 Watt
IP 44
IP 54
1.5 kW
1.7 kW
250 bar (25 MPa)
3.0 l/min
3.5 l/min
3.5 l/min
(220 Volt~,
60 Hz)
2.5 l/min
3.2 l/min
3.1 l/min
(220 Volt~,
60 Hz)
0.027 inch
0.031 inch
– 0.69 mm
– 0.79 mm
43°C
25.000 mPa·s
40 kg
43 kg
0.9 Litre, ESSO NUTO H 22
2 bar (0.2 MPa)
74 dB (A)*
GB
1
transport in vehicle
Unroll high-pressure hose and lay it over the shaft. Secure the
unit by means of suitable fastening.
4.
StartIng operatIon
4.1
unIt wIth SuctIon SyStem
1.
Screw off dust protection cap (fig. 6, item 1).
2.
Pay attention to clean sealing areas on the connections.
Pay attention to the fact that the red inlet (2) is inserted into
the coating material inlet.
3.
Screw and tighten the union nut (3) on the suction pipe (4)
onto the coating material inlet (5) with the accompanying
spanner 41 mm.
4.
Screw the union nut (6) on the return pipe (7) onto the
connection (8).
4.2
unIt wIth upper hopper (5 lItreS)
1.
Screw off dust protection cap (fig. 7, item 1).
2.
Pay attention to clean sealing areas on the connections.
5
2
1 8
6
7
Super Finish 27 • 31
3
4
Hide quick links:
Advertisement
Table of Contents
