Suction Filter; High-Pressure Filter (Accessory); Cleaning Airless Spray Gun G 12 - WAGNER Super Finish 27 Operating Manual

Cleaning unit from outside
Danger of short circuit through penetrating
water! never spray down the unit with high-
pressure or high-pressure steam cleaners.
Danger
Wipe down unit externally with a cloth which has been im-
mersed in a suitable cleaning agent.
Clean socket and the multifunction switch areas meticulously
also.
8.2

SuctIon FIlter

Clean filters also guarantee the maximum con-
i
veyance quantity, constant spraying pressure
and faultless function of the unit.
•
unit with suction system
1. Screw off the filter (fig. 13) from suction pipe.
2. Clean or replace the filter. Carry out cleaning with a hard
brush and an appropriate cleaning agent.

•
unit with upper hopper
1. Release screws with a screwdriver (fig. 14,item 1).
2. Lift (2) and remove filter disk with a screwdriver.
3. Clean or replace the filter disk. Carry out cleaning with a
hard brush and an appropriate cleaning agent.

8.3

hIgh-preSSure FIlter (acceSSory)

•
Switch off unit – set multifunction switch to
•
Open high-pressure filter and clean filter insert; in addition:
1. Insert open-ended spanner into the groove of the filter
housing (fig. 15, item 1) – screw out filter housing.
2. Remove filter housing (1), supporting part (2), centring ring
34
GB
3.
4.
5.
•
•
•
Intake filter in airless spray gun
dismounting (fig. 16)
1.
2.
1
2
3.
Mounting
1.
2.
3.
(OFF).
(4) and O-ring (5).
Roll in filter insert (3) (for filter insert with 70 mesh this is not
necessary) and pull out of supporting part (2).
Clean all parts with appropriate cleaning agent. If pressure
air is existent – blow through filter insert and supporting
part.
Remount high-pressure filter.

8.4

cleanIng aIrleSS Spray gun g 12

Rinse Airless spray gun with an appropriate cleaning agent.
Clean tip thoroughly with appropriate cleaning agent so that
no coating material residue re-mains.
Thoroughly clean the outside of the Airless spray gun.
Pull protective guard (1) forward vigorously.
Screw grip (2) out of the gun housing. Remove intake filter
(3).
Intake filter congested or defective – replace.
Place intake filter (3) with the long cone into the gun
housing.
Screw in grip (2) into the gun housing and tighten.
Slot in protective guard (1).

a n y
G e rm
in
d e
M a
2
G 1
x .
m a p si
0 0
a r
3 9 0 b
2 7
1
1
2
3
4
5
3
2
Super Finish 27 • 31