Wiznet WizFi630 User Manual page 67

However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
WARNING: This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the modifications are
expressly approved in the instruction manual. The user could lose the authority to operate
this equipment if an unauthorized change or modification is made.
This device complies with Part 15 of the FCC rules. Operation is subject to following two
conditions: 1. this device may not cause harmful interference and 2. This device must accept
any interference received including interference that may cause undesired Operation of this
device.
The changes or modifications not expressly approved by the party responsible for
Compliance could void the user's authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna
must not be co-located or operating to conjunction with any other antenna or transmitter,
except if installed in compliance with FCC Multi Transmitter procedures.
To inherit the modular approval, the antennas for this transmitter must be installed to
provide a separation distance of 20cm from all persons and must not be co-located or
operating in Conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, Pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable Protection against harmful interference in a
residential installation. This equipment generates Uses and can radiate radio frequency
energy and, if not installed and used in accordance With the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference, Will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an Outlet on a circuit different from that to which the
receiver is connected.
67
© Copyright 2012 WIZnet Co., Ltd. All rights reserved.