Item
Image Enhance
HexDump
Draft Mode
Line Termination
Output Color
PostScript (DocuPrint C1110 only)
Specifies the settings related to PostScript.
Note
• You need to restart the printer to activate the new settings. After making the settings, switch the printer
off and then on again.
Item
PS Error Report
PS Job Time-out
Paper Select Mode
96
5 Control Panel Menus
Sets whether to perform image enhancement.
Image enhancement is a feature that makes the boundary line between black and white
smoother to decrease jags and enhance the visual appearance.
• [On] (default)
• [Off]
Sets whether to print the data sent from a computer in ASCII codes corresponding to
the hexadecimal notation format in order to check the data contents.
• [Disable] (default)
• [Enable]
Sets whether to print in the draft mode. This mode increases print speed but decreases
print quality.
• [Disable] (default)
• [Enable]
Sets the line termination control codes. Set how you want the printer to interpret CR, LF
and FF control codes.
• [Off] (default)
The line termination command is not added.
CR=CR, LF=LF, FF=FF
• [Add-LF]
The LF command is added.
CR=CR+LF, LF=LF, FF=FF
• [Add-CR]
The CR command is added.
CR=CR, LF=CR+LF, FF=CR+FF
• [CR-XX]
The CR and LF commands are added.
CR=CR+LF, LF=CR+LF, FF=CR+FF
Sets the color mode. This settings is used when the color printing mode setting is not
specified for the print job that is sent to the printer.
• [Black] (default)
Prints in the black and white mode.
• [Color]
Prints in the color mode.
Sets whether to print an error report in case of a PostScript error.
• [On] (default)
• [Off]
Sets the amount of time the printer waits for a print job. If a time-out occurs during data
reception, the printer stops the reception and starts printing the received data.
Specify the time-out value in 1 minute increments.
• [Off] (default)
Disables the job time-out.
• [1 Minutes] to [900 Minutes]
Sets whether to enable the PostScript DMS (Deferred Media Selection) feature.
• [Auto] (default)
Enables the DMS feature.
• [Select From Tray]
Disables the DMS feature and selects a paper tray.
Description
Description