Advertisement
1.0 INSTALLATION
1.1 Model Identification and Rating
MODEL NUMBER AND NAMEPLATE INFORMATION is located on the nameplate
label on the rear cover of the oven.
NOTE: An electrical schematic is supplied with the oven. It is located in the
back of the Display Panel in an envelope. An electrical schematic is also
provided in the Owner's Manual for the oven. Please return the schematic to
the storage envelope for future use.
SERIAL NUMBER IDENTIFICATION is located on a serial number label attached
underneath the lower right corner of the oven frame.
The following provides an identification of serial numbers assigned by TurboChef to
specific currently manufactured oven types, and a brief description of the ovens.
D-1 Oven
(Domestic) Serial Numbers 10001 through 10055.
First of this series was produced in April 1994. Cook Chamber, Frame,
Door and outer covers made of stainless steel.
D1-A Oven (Domestic) Serial Numbers 10056 through 10092.
Same basic oven as the D-1. Door was changed from stainless steel to
nickel-plated aluminum, to lighten it for easier operation and removal.
The machined door flange on the previous model became a formed part.
D2-EC Oven (European) Serial Numbers 10141 through 10210.
Extension of D1-A. The height of the cook chamber increased from 4" to
5.25" to allow cooking of a greater variety of foods. Heater element
terminals extend through the top cover of the heat exchanger rather than
the left side, for easier assembly. A secondary audio alarm has been
added to improve volume at cook cycle completion.
connector is brought to the rear of the oven for computerized
downloading of recipes. Power wiring is WYE connected, 50 Hz.
(Domestic) Serial Numbers 10101 through 10120, 100101 → → → → ,
D2B Oven
, 300101 → → → → , 400101 → → → → .
This domestic version has the height of the cook chamber increased from
4" to 5.25" to allow cooking of a greater variety of foods. The electrical
control box moved from the front of the oven to the right side. Heater
element terminals extend through the top cover of the heat exchanger
rather than the left side, for easier assembly. A secondary audio alarm
has been added to improve volume at cook cycle completion. A D-Sub 9
pin connector is brought to the rear of the oven for computerized
downloading of recipes. (Same as D2B-EC except power wiring is delta
connected, 60 Hz.)
D2B-EC Oven (European) Serial Numbers 10211 through 10220, 10221(First CE
Qualified) through 10446, 110101 → → → → , 310101 → → → → , 410101 → → → → .
Same as the D2B Oven, except power wiring is WYE connected, 50 Hz.
TurboChef, Inc.
700-0655.DOC Rev B February 15, 1997
A D-Sub 9 pin
Page 7 of 62
Advertisement
