Lighting System - MOTO GUZZI Le Mans 850 Additions And Changes To The Workshop Manual

ACOUSTIC SYSTEM
For this vehicle It includes :
- horn ;
- ground. provided by the frame.
F •• tur ..
Electric horn , high pitched lone, Manufacturer
. Selli - (90/ 12/ 2).
Absorption 3 A.
LIGHTING SYSTEM
H •• dllght (fig. 379)
The headlight of this vehicle fits a two-filament
bulb 40/ 45 W -12 V
tor
high and low beam and
a 5 W ·12 V zulb for parking or town driving
light.
Replacement of the he.dllght bulbs
(fig.
379)
Undo the screw «B., down on the headlight in-
sert, slip off the two bulb sockets and replace
Ihe bulbs.
Tall light (fig. 379)
The tail light fits a two-filament bulb 5/ 21 W-
12 V.
To remove this bulb loosen the screws ,, 0 .. se-
curing reffector to tail light, push the bulb inward
turn and slip it off the socket.
In nt-ftttIng the
r.nee1or
onto the tall light do
not lock the tere . . exceuwety not to break
the
reftector ItseH.
Turning Indicator IIghti
These fit a 21 W -12 V bulb
To remove the bulbs loosen the screws securing
the reflectors, push the bulbs inward tum and
slip them off the socket.
In re-fitting the reh'ector do not lock the screws
excessively not to break the reflector itself.
Instrument p.,....
kin
.nd rey. counters
These parts fit some bulbs which are replaced
as follows:
Km and rey. countel'l
They fit a 3 W 12 V bulb, to replace slip it off the
bulb socket.
Instrument panel
It fits five warning lights with 1,2 W - 12 V bulbs
whic h can be replaced as follows.
19.
Warning lights: _H· I - 0;1 - h - gen- : take the
holder
off
the instrument panel and slip the bulb
off the socket.
Warning light warning the fluid level in master
cyiinder for rear and left front brake; slip the
bulb off the socket.
Bulb lIat
Head light :
- high aod low beam
- park town driving
TaH light:
- number plate lighting
- park stop light
Turn indicator lights
km and rev. counters
Instrument panel
40/ 45 W -12 V
3 W
-12
V
l
5/ 21 W-12V
4 bulbs 21 W-12V
2 bulbs 3W-12V
5 bulbs 1,2W-12V
Headlight beam adjustment (fig. 379)
For a safe riding and not to trouble crossi ng
riders, the headlight beam has always to be set
at a correct height.
For horizontal setti ng act on screw - A-.
For vertical setting undo the two screws -C ..
securing the headlight and shift it by hand up-
wards or down wards until to reach the correct
height.
The center of the hig h beam must not be higher
than m 0,86 measured at 3 m distance with mo-
torcycle not on stand and rider on saddle.
Instrument panel (fig, 380)
- 1 km counter.
- 2 Rev. counter.
- 3 Orange neutral Indicator. It lights when
the gearbox is neutral position.
- 4 Green warning light indicating parking
light on.
- Red warning light, oil pressure gauge. It goes
out when the pressure is sufficient for normal
engine lubrication . Should it not go out, this
means that the oit pressure is not correct, in
th is case the engine has to be stopped and suit-
able checkings are to be carried out.
- 6 High beam warning light, blue.