Wheels And Brakes - MOTO GUZZI Le Mans 850 Additions And Changes To The Workshop Manual

WHEELS AND BRAKES
Removal of the front wheel from the fork
,ega
(fig. 361)
Proceed as follows:
- Fit the stand 14912450 under the engine
sump, the side holding the gearbox must face
the front wheel, then screw In the stand in such
a way as to tift the vehicle.
- Loosen the screws securing the caliper " A.
to the front fork left leg.
- Undo the nut .. 8,. on the wheel spindle, left
side.
- Undo the screws .. C· securing spindle to
fork covers.
- Slide out the spindle ,,0. from fork covers
and wheel hub, the-n take the wheel off right ca-
liper and fork covers.
In r&-fitting reverse the sequence, remember to
fit the spacer .. E. between wheel hub and front
fork left cover.
Removal 0' the rear wheel from the rear
drive box and the left arm 01 the rear
..tnglng fork (see fig. 362)
Proceed as follows :
- Set the vehicle on the center stand.
- Undo the nut "E. on the wheel spindle, reBr
drive box side.
- Undo the screw securing the spindle on the
rear swinging fork arm.
- Take the spindle . 0. off rear drive box, wheel
hub and rear swinging fork arm.
- Take the braking disc off caliper "E • •
- Remove the brake caliper ass.y and secure
it to the frame.
188
- Lean the vehicle to the right side to take the
wheel " F. off rear swinging fork arm and rear
drive box.
In re-fitting reverse the sequence paying atten-
tion to fit the caliper ass.y onto the rear swin-
ging fork left arm .
Truing the braking diM: betw .. n the brake pads
(fig.
322)
To correctly true the braking disc between the
braking pads
.A. it is necessary to increase or
decrease the shim quantity on the screws " B.
securing the caliper to:
Front fork left cover.
- Front fork right cover.
- Rear wheel caliper bracket
until the disc is correctly trued between the
pads.
The shims are available in the following thichk-
nesses:
- partn . 95 10 0232 mm 0,5
- partn. 95100233 mm 0,8 .
Replacing the braking pads In callpera (fig. 314)
For this replacement it is necessary to remove
the hole cover .A., then to take off the pad
retai ner pins " B., the positsioning spring
Ole.
and the pin ,, 0 .. ; then replace the pads Ol E • .
The pads replaced, it is necessary to operate
several times the hand control lever or the foot
control pedal until the pads properly couple
the discs.