Advertisement
6.1.2.5 AUTO mode
In this mode, the system selects COOL, HEAT and FAN mode automatically according to the change of ambient temperature.
The protection function is the same with that of COOL/HEAT mode.
The unit will adjust the running frequency of the compressor automatically according to the change of ambient temperature.
6.1.3 Other control
6.1.3.1 ON / OFF
Each time the On/Off button of the remote controller is pressed, the On/Off state will switch once.
6.1.3.2 MODE selection
Press the MODE button on the remote controller to select and display the following modes:
AUTO, COOL, DRY, FAN, HEAT,AUTO.
6.1.3.3 TEMP. setting button
Each time TEMP + or TEMP - button is pressed, the set temperature will be increased or decreased by 1 .Adjusting range
is 16~30
. In AUTO mode, this button does not function.
6.1.3.4 AUTO key
When the unit is running, press AUTO key,the unit will be stopped.
When the unit is stop, press AUTO key,the unit will run under AUTO mode and the swing motor starts. If there is remote
control signal, the main unit will run according to the signal.
6.1.3.5 Timer control
The unit is turned on or off according to the timer set by the remote controller.
6.1.3.6 Sleep Function
Setting SLEEP function under COOL or DEHUMIDIFY mode, the preset temperature will automatically rise by 1
hour and rise by another 1
run at this preset temperature.
Setting SLEEP function under HEAT mode, the preset temperature will automatically decrease by 1
decrease by another 1 after 2 hours. Preset temperature will decrease by 2
unit will run at this preset temperature.
If set sleep function under fan or auto mode, the
set temperature will remain unchanged.
Once the sleep function is set, the indoor fan will
run at low speed.
6.1.3.7 Indoor fan control
Use the remote controller to set the indoor fan running at HIGH, MED or LOW speed. At this time the fan will run
at high, medium or low speed. It can also be set to AUTO and the indoor fan will select fan speed(HIGH, MED or
LOW) automatically according to ambient temperature.
The indoor fan, once running at one speed, will not turn to another speed within 3.5 minutes.
after 2 hours. Preset temperature will rise by 2
T
+1
preset
T
preset
1 hour
1 hour
T
preset
T
preset
in total within 2 hours. After that, the unit will
T
+2
preset
2 hours
Over 2 hours
2 hours
Over 2 hours
-1
T
-2
preset
Set the Temperature T
Set the Temperature T
preset
after 1hour and
in total within 2 hours. After that, the
preset
after 1
Advertisement
