Menvier Security TS690 Operator's Manual page 41

A passcode has been incorrectly entered more than four times at a remote
CODE TAMPER 02
keypad (keypad 02). To silence the alarm enter a correct passcode. To
17:30 01 Jan
reset the alarm simply enter your passcode follows by [ESC].
C.TMP 02 C.TMP 02
PT. 0 2
A delayed full alarm has occurred from a detection circuit (circuit 05). This
DELAY ALARM 05
message is normally display after unsetting the alarm system. Before the
17:30 01 Jan
system can be set again the alarm system must be reset, see "Resetting
DELAY 05 DELAY 05
After an Alarm" on page 11.
AD. 0 5
An entry time out alarm has occurred from a detection circuit (circuit 01).
ENTRY ALARM 01
This is normally caused when the entry procedure is started and the system is
17:30 01 Jan
not unset before the timer expires. Before the system can be set again the
ENTRY 01 ENTRY 01
alarm system must be reset, see "Resetting After an Alarm" on page 11.
EA. 0 1
A fire alarm has occurred from a detection circuit (circuit 07). The internal
FIRE ALARM 07
sounder will generate a distinctive fire alarm tone and the external sounder
17:30 01 Jan
is pulsed on and off. To silence the alarm simply enter your passcode. To
FIRE 07 FIRE 07
reset the alarm simply enter your passcode again followed by [ESC].
FA. 0 7
The auxiliary supply used for powering detection devices has blown its fuse.
FUSE BLOWN 01
You will not be able to set the alarm system until the fault is rectified. Contact
17:30 01 Jan
your alarm company for further advice.
FUSE 01 FUSE 01
FB. 0 1
A panic alarm (PA) has occurred from a detection circuit (circuit 08). To
PA ALARM 08
silence the alarm simply enter your passcode. Reset the panic alarm
17:30 01 Jan
device if required (normally with a key). To reset the alarm simply enter your
PA�ALM 08 PA�ALM 08
passcode again followed by [ESC].
PA. 0 8
A panic alarm (PA) passcode has been entered at a remote keypad by a
PA CODE 15
user (user 15). To silence the alarm simply enter your passcode. To reset the
17:30 01 Jan
alarm simply enter your passcode again followed by [ESC].
PANIC 15 PANIC 15
PC. 1 5
Display Messages (Cont.)
41