Install The Hardware - Axis Q6042-C Installation Manual

AXIS Q604 Series
DC output
Configurable
I/O 1 (Input or Output)
Configurable
I/O 2 (Input or Output)

Install the Hardware

NO TICE NO NO TICE TICE
• The product shall be connected using a shielded network cable (STP) or an optical fibre
cable. All cables connecting the product to the network shall be intended for their
specific use. Make sure that the network devices are connected in accordance with
the manufacturer's instructions. For information about regulatory requirements, see
Regulatory Information on page 2 .
• The product has a dehumidifying membrane for maintaining low humidity levels inside the
dome. To avoid condensation, do not disassemble the product in rain or damp conditions.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
The Axis product can be installed with the cables routed through or along the wall or roof.
In areas where the temperature is above 60 °C (140 °F), the product shall be placed in a restricted
access location.
Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
• Remove the protective packaging between the camera and the sunshield before installing
the camera.
• A smoked dome cover can be purchased from your Axis reseller. To replace the dome
cover, see page 23.
• A standard or high capacity SD card (not included) can be used to store recordings locally
in the product. To install an SD card, see page 24.
• To install the power supply (sold separately) and the supplied media converter switch, see
page 24.
• To install the network camera using a compatible bracket from AXIS T91A Mounting
Accessories (sold separately), see Install the Network Camera.
2
Power out
3
Digital input
Digital output (transistor –
open collector)
5
Digital input
Digital output (transistor –
open collector)
22
12 V DC, 50 mA
0 to max 30 V DC
0 to max 30 V DC,
open drain, 100 mA
0 to max 30 V DC
0 to max 30 V DC,
open drain, 100 mA