Table of Contents
Advertisement
Install the Hardware
NO TICE
TICE
NO
NO
TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) on
page 2 .
Mount the product with the dome facing downward.
Read all the instructions before preparing to install the network camera since several installation
preparation steps require removing the top cover and would benefit from being completed together.
The sunshield must be removed to install/remove an SD card.
•
Remove the protective packaging before installing the camera.
•
The product is supplied with a clear transparent dome cover (premounted) and a smoked
transparent dome cover. To replace the dome cover, see page 14.
•
A standard or high capacity SD card (not included) can be used to store recordings
locally in the product. See page 14.
•
To install the product using a compatible bracket from AXIS T91A Mounting Accessories
(sold separately), see page 15.
Remove the Protective Packaging
See Hardware Overview on page 9 for location of components.
1. Loosen the four top cover screws and remove the top cover.
2. Remove the protective packaging.
1
Protective packaging
AXIS P55-E Network Camera Series
13
Advertisement
Table of Contents
