Grate; Glass Cleaning; Ash Removal; Refractory - Heatilator Icon I100 Owner's Manual

Remove screws,
lift top cover.
Top Cover
Cap
Chimney
TR11/TR11T
Round Termination Cap
Figure 4.1 Chimney & Termination Cap Cleaning
C. Grate
Frequency: After each ash removal
By: Homeowner
Inspect grate for:
• Warping or sagging 1-1/2 in. (38 mm) or more
• Broken welds
• Burn-through of grate bars
For safe operation, replace only with the approved grate
from Hearth & Homes Technologies.
D. Glass Cleaning
Frequency: As necessary
By: Homeowner
Tools Needed: Vinegar or glass cleaner, soft towel
• Clean glass with a non-abrasive glass cleaner. Use a
damp cloth dipped in wood ashes or a commercially
available oven cleaner. Remove any oven cleaner
residue with a glass cleaner or soap and water.
Remove 4 screws
and lift top pan off.
Cap
Slip
Section
ST1175
Square Termination Cap
Heatilator • ICON I100 Owner's Manual • 4013-264 • Rev E • 11/25/13
Remove 2 screws from
the front and back and
lift the top off.
Screw
TCT1175
Terra Cotta
Termination Cap
E. Ash Removal
Frequency:
By: Homeowner
Tools Needed: Covered metal container, metal
shovel, fireplace broom
WARNING! Risk of Fire! DO NOT remove ashes until
the fire is out and the fireplace is cold.
• Ashes should be placed in metal container with tight
fitting lid.
• The closed container of ashes should be placed
on a noncombustible floor or on the ground, well
away from all combustible materials, pending final
disposal.
• If the ashes are disposed of by burial in soil or
otherwise locally dispersed, they should be retained
in the closed container until all cinders have
thoroughly cooled.
F. Refractory
Frequency:
By:
Tools
Needed:
• Inspect condition of refractory. Replace if crumbly
or otherwise deteriorated, or if cracks exceed 1/4 in.
(6 mm).
Remove 8 screws
and lift top.
Top
DTO/DTS Series
Termination Cap
As necessary
Top
15