Install Screens; Install Mortar (Optional); Grate - Heatilator BIR42-B Installation Manual

D. Install Screens
• Lay one screen panel flat and slide the round end of the
rod through the rings starting at the handle side of the
screen. Leave the last ring off the rod.
• Insert the rod through the hole in the bracket. Slip the
last ring over the rod on the other side of the bracket.
• Fasten the flat end of the screen rod back in place using
the screw removed earlier.
• Repeat for the other screen panel.
Round end of Rod through rings,
then into Screen Rod Clip
Figure 8.3

Install Screens

E. Install Mortar (Optional)
The brick panels have been designed for installation
without the use of mortar being necessary. If the look of
mortar is preferred, it is available and can be installed.
Follow the directions on the container for mixing. Clean
sparingly as paint will rub off and may need to be touched
up. Touch up paint is available as an accessory.
Note: Herringbone refractory may require two buckets
of mortar. The Traditional requires only one.
F. Grate
• Install the grate if a gas log set is not going to be installed.
• Position the rear grate legs into the grate retainers.
36
Top of Fireplace
Rod Screen
Clip
Inside
Firebox
Heatilator • Birmingham 36-B Installation Manual • 4059-709 • Rev AB • 06/23