Stromversorgung; Power Supply; Process Of Cleaning; End Of The Application - HOS Orbot Operation Manual

Fig. 19
WARNING: Make sure a suitable pad or brush is mounted before starting the machine. The
immediate contact of the floor and driver plate without a pad can lead to serious damage of the
floor and/or the machine.

Power Supply

• USA/Canada - Plug the power cord into a 110 volt outlet with a supply of at least 11 amps.
• Europe - Plug the power cord into a 230 volt outlet with a supply of at least 6 amps.
• Australia - Plug the power cord into a 240 volt outlet with a supply of at least 5 amps.
• If you are in need of a longer power cord, make sure it is a minimum of 12/3 gauge for 100-110 Volt
circuits or 6 mm² extension cord for 230-240 Volt circuits.

Process of Cleaning

• For effective floor cleaning with the ORBOT SprayBorg, move the machine forward and backwards.
We recommend you to wet the floor as you move the machine forward, releasing the spray button
when you move the machine backwards.
• To increase the pressure and cleaning effect on certain floors like tile and grout, you can lift the
machine frame up, raising the wheels off the ground. When lifting the wheels off the ground the full
weight of the machine lies on the machine base.
• WARNING: Make sure the surface to be cleaned is not damaged by the increase in pressure. Omit
this measure on very sensitive floors.

End of the Application

• Turn off the machine by putting the red on / off switch to "O".
• If you used a cleaning solution, rinse the pump system with clear water. Install a bottle filled with
clear water in the cage holder (to exchange the water bottle, see pg. 9). If you do not have an open
area to spray and rinse the pump, we recommend placing a SuperZorb pad on the floor in front of
the spray jets and directly spray onto it. Press and hold down the spray button until the water is
totally clear.
WARNING: Omitting this rinsing process can lead to internal hose, filter, and/or pump damage.
• To store the base in the upright position, press down the handle frame with the right hand and lift
up the base with the left hand by grabbing the base handle (Fig. 20, 21).
6