Technical Details Orbot Sprayborg; Usage; General Advices; Unpacking And Initial Operation - HOS Orbot Operation Manual

TEcHNIcAL DETAILs ORbOT sPRAYbORG

Motor: 1HP, 100-240V/50-60Hz, 6 amps (50Hz)/11amp (60Hz)
RPM: 1725 (60Hz)/1400 (50Hz)
Base diameter: 17"/43 cm
Orbital diameter: 3/8" (9.5 mm)
Weight: 82 Lbs./37 kg (Orbot)/102 Lbs./46 kg (Orbot SprayBorg)
Height: 48" (122 cm)
Compact size for transport and storage: 30" (76 cm)
Wheels: 10"/25 cm Diameter, resistant to chemicals

UsAGE

NOTE: The Orbot SprayBorg is not suitable for use or storage in wet conditions.

General Advices

• Everyone who uses the machine should have read these instructions carefully. All persons who
operate the machine or stay close should take appropriate safety precautions.
• Use the ORBOT SprayBorg only for intended application.
• Do not use accessories which are not designed and recommended by the manufacturer.
• Do not use the machine if the switch does not turn it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must be repaired
• Disconnect the plug from the power source before making any adjustments, changing accessories,
or storing. Such preventive safety measures reduce the risk of starting the machine accidentally.
• Do not use a damaged accessory. Before each use inspect the accessory such as the pad driver
for cracks, tears or excess wear. If the machine or accessory is dropped, inspect for damage to
install an undamaged accessory.
• Repair the damaged machine before the next application.

Unpacking and Initial Operation

• Open the shipping box on both sides, remove the packaging material and roll the machine out of
the box.
• Put the handle in an upright position (Fig. 1, 2).
Fig. 1 Fig. 2
2