Hos Environ Hp Encapsulation Cleaning Solution; Application On Different Floor Types; Carpet Cleaning; Cleaning Hard Floors - HOS Orbot Operation Manual

HOS Environ HP Encapsulation Cleaning Solution

• The formula of the environmentally friendly Environ HP Encapsulation Cleaning Solution is water
based and contains a liquid polymer. It captures dirt particles which then can be easily removed.
• The solution is particularly suitable for carpet cleaning.
• The mixing ratio of Environ HP is 1-4 oz/gal. (10-40 ml a liter), depending on the level of soil.
• Enter the appropriate solution quantity in a HOS water bottle and store it in the provided holder as
described on page 9.
• Spray the desired amount of solution on the surface by using the momentary operated spray button
located on the right handle of the machine.
• Rinse the spray system after each use of the cleaning solution with clean water (see page 16.
WARNING: Omitting the rinsing process can lead to damage of the hoses, filters, and pump
system.
• WARNING: As recommended with all chemicals, keep the Environ HP Encapsulation cleaning
solution away from children!

Application on different Floor Types

Carpet Cleaning

• Vacuum the carpet thoroughly before applying the ORBOT. This way, large dirt particles are
removed, allowing the ORBOT application to be more effective.
• Depending on the level of soil and the nature of the carpet, select a suitable textile cleaning pad.
SuperZorb pads are suitable for all types of carpets, while AgiClean pads are suitable in particular
for the cleaning of heavily soiled commercial carpets.
• Attach a SuperZorb pad on the driver plate by laying the pad on the floor and centering the
machine base over the pad.
• For gentle cleaning on sensitive long-fiber carpets and for easy handling on rough carpets, use the
HOS Gliders.
• Each section of the carpet should be moistened first by using the spray button when you move
forward. The carpet should be cleaned by going forward and backwards two to three times, while
only spraying on the first pass in order to keep the drying time low. Depending on the level of soil
and the nature of the carpet, this process can be shortened or extended.
• As required, carpets can be vacuumed again after the use of the ORBOT.

Cleaning Hard Floors

• We recommend you to remove dust and coarse dirt from the surface before applying the ORBOT.
• Choose a suitable pad according to the application (see page 13-14).
• Place the driver plate on the pad by putting the pad on the floor and centering the machine base
over it.
• Each section of the surface should be cleaned by moving the ORBOT two to three times forward
and backwards and adding water and cleaning solution as needed. Depending on the soil
contamination and the floor type this process can be shortened or extended.

Grinding and Polishing Stone Floors

• To remove any dirt that might leave scratches, we recommend you to clean the surface with a
squeegee wand or wet-dry vacuum before applying the ORBOT. This cleaning process should be
repeated after each step with the HOS StoneFlash pads.
• One StoneFlash pad step cycle consists of five passes moving forward and backwards. Depending
on the nature of the floor, this process can be shortened or extended.
15