Accessories And Applications; Hos Driver Plates; Hos Standard Driver Plate; Hos Stoneflash Driver Plate - HOS Orbot Operation Manual

Fig. 34
IMPORTANT SAFETY INSTRUCTION: Tighten the screws sufficiently to avoid disengagement of the driver
plate from the machine base during operation.
To avoid stripping the screws do not over tighten. An electric screwdriver with a clutch will ensure that
stripping will not occur.

AccEssORIEs AND APPLIcATIONs

WARNING: Never store the HOS accessories in wet conditions! Keep the HOS accessories away from
extreme heat and from chemicals!

HOS Driver Plates

WARNING: Exclusively use ORBOT SprayBorg designed driver plates only. The use of other non HOS driver
plates will damage the machine and its mechanical action.
The driver plates are fastened on the machine base with four countersink screws. For more information on
how to change the driver plate see page 11.

HOS Standard Driver Plate

• The HOS standard driver plate (15" in diameter/38 cm) is supplied as a standard with the ORBOT
SprayBorg. It is suitable for the use with all HOS pads for textile and hard floor applications.
• The HOS pads can be easily attached and removed from the Velcro driver disc. More information
on how the exchange the pads can be found on page 11.
• After frequent use, lint will stick to the Velcro surface of the driver plate, which hinders a secure
attachment of the cleaning pads and will increase wear and tear to the pads.
• Change the HOS Velcro driver disc often as needed to avoid problems as described on page 16.

HOS StoneFlash Driver Plate

• The HOS StoneFlash driver plate is particularly well suited for the use with the HOS StoneFlash
pads due to its catchy Velcro hook surface. The texture of the surface improves the adhesion and
thus promotes the longevity of the pads.
HOS Lippage Driver Plate
• Eight interchangeable diamond discs are mounted to the HOS lippage driver plate. These discs
stick to a Velcro surface and can be changed by levering them out of their indentation with a
suitable tool.
• Depending on the floor type and the desired results, diamond discs of various grit levels can be
chosen.
• Lippage driver is suited for the leveling of uneven stone floors. Lippage, deep scratches and
impurities can be removed.
• The lippage driver plate should be rinsed after each application.
Fig. 35 Fig. 36
12