HOS Orbot Operation Manual page 8

Fig. 13
This priming procedure should be repeated after every change of the water tank. For standard
priming 10 seconds is usually sufficient.
• By adjusting the yellow lever you can vary the spray pressure. The further you move the lever
counter-clockwise upwards, the higher the water pressure. A horizontal position means maximum
water output at maximum pressure (Fig. 16)
Fig. 14 Fig. 15
• Adjust the spray jets on the machine base to the desired position. For most floor cleaning
applications adjust the spray jets so that they spray about 6 inches (15 cm) in front of the base.
Fig. 17
• Set the handle position to the desired height by pulling and releasing the black knob (Fig. 18) with
the left hand. While holding the black knob out, raise or lower the handle frame with your right
hand. To fix the handle frame into place, release the black knob so that it locks firmly into one of the
holes provided.
Fig. 18
• NOTE: A detailed description of the ORBOT Weight Kit for maintaining hard floors can be found on
page 9.
• To turn the machine on, press the red power button (power button may also be black in color) on
the left end of the handle. Position "0" is off and position "I" is on (Fig. 19).
Fig. 16
5