Additional Instructions; Weight Kit Installation; Hos Brush Installation; Changing The Water Bottle - HOS Orbot Operation Manual

ADDITIONAL INsTRUcTIONs

Weight Kit Installation

• The total weight of the weight kit is 40 lbs.
• Put the weights on top of the white mounting plates located on the sides of the machine base.
Fig. 27
• Put the four screws into the holes provided on the weight plates and fasten by turning clockwise.
Once the screws have threaded at least 5 full turns, tighten the wing nuts by turning them
clockwise, until the weights fit securely to the base.
• WARNING: Make sure that the weights are securely attached to the base. Loose weights can
cause serious damage.
• For storage and transport we recommend removing the weight kit. The machine can be transported
more easily without the weights.

HOS Brush Installation

• Put the machine base in an upright position, sitting on the foot of the bumper.
• Remove the driver plate by removing the four countersink screws in the center of the plate using
an electric screwdriver.
• WARNING: It is important to only use a PH3 screwdriver bit. Smaller bit sizes can damage the
screw heads and leave sharp edges, which can tear or snag the SuperZorb Pads.
• Mount the HOS brush with the same countersink screws used for mounting the driver plates.
• IMPORTANT SAFETY INSTRUCTION: Tighten the screws sufficiently to avoid disengagement of the
brush from the machine during operation.
To avoid stripping the screws do not over tighten. An electric screwdriver with a clutch will ensure
that stripping will not occur.
• For further instructions for the storage of the HOS brush see page 15.

Changing the Water Bottle

• To put the water bottle in the cage holder, place the bottle at an angle over the cage hoop. Push
the bottle into the cage hoop so that you can push it without much effort into the cage hoop holder.
Push the bottle down until it rests firmly (see figure 7-9, page 5)
• To remove the water bottle from the cage holder, proceed in reverse order: Pull the water bottle
out of the holder, as soon as the bottom of the bottle hits the cage hoop, tilt the bottle and pull it up
and out at an angle. Remove the bottle from the cage holder and place it next to the machine on the
floor (figure 29-31).
Fig. 28
9