Start-Up; Turn Off - Cxb Models; Turn Off/Standby Mode - Cxp Models; Balance Zero Display - KERN CXB 3K0.2 Operating Instruction

7.5.1 Start-up

Turn on scales with ON/OFF switch (left).
The balance will carry out a self-test As soon as the weight display shows "0" in all
the three display windows your balance is ready to weigh.
On CXP models (with RS 232) an internal number appears before the balance counts
down to zero.
a
PRE-
TARE
7.5.2 Turn off – CXB models
• Turn off balance by operating the ON/OFF switch (left)
7.5.3 Turn off/standby mode – CXP models
• To turn off the balance for a long period of time use the ON/OFF switch
(left).
• To turn off the balance for a short period of time use the
To do this, press the
standby mode (this avoids the required warm-up time). Restart the balance by
pressing the

7.5.4 Balance zero display

Environmental influences can lead to the exact figure of zero not being displayed in
spite of an empty weighing dish. It is, however, possible to reset your balance to zero
at any time and thus ensure that weighing really does commence at zero. Setting to
zero when a weight is applied is only possible within a certain type-dependent range.
In the event that the balance cannot be reset to zero with an applied weight, this
range has been exceeded (± 0,2 % max).
To reset the balance to zero, press key
symbol on the display.

7.5.5 Stability display

If a triangle [ ] pops up next to the [
the balance is in a stable state. If the status is instable the [
CXB/CXP-BA-e-1016
0
key until "OFF" is displayed. Balance is in
key.
] symbol on the display,
0
M+
. A triangle [ ] pops up next to the [ a ]
] display disappears.
0
key.
19