Removing The Media Tray; Installing The Media Tray - IBM BladeCenter T 8720 Installation And User Manual

Removing the media tray

Complete the following steps to remove the media tray in the front of the
BladeCenter T unit:
1. Press the blue release button on the front of the media-tray module to release
2. Make sure that the release latches are in the open position (90° from the closed
3. Grasp the media tray at the front of each side of the module and carefully pull
4. Within 1 minute, install another media tray into the BladeCenter T unit.

Installing the media tray

Complete the following steps to install the media tray in the front of the BladeCenter
T unit:
1. Hold the media tray at the front of each side of the module and orient the media
2. Make sure that the release latches are in the open position (90° from the closed
3. Slide the media tray forward into the media-tray bay until it stops.
4. Push the media tray in until you feel it lock into position.
5. Push both release latches in until they lock into the latch next to the blue
6. Make sure that the power LED is lit on the system-status panel.
7. If you have other modules to install at the front of the unit, do so now.
the latches. The latches swing out.
position).
the module all the way out of the bay. Set it in a safe place.
tray to the top of the media-tray bay. Carefully position the module into the rails
in the media-tray bay.
position).
release button.
Otherwise, reinstall the bezel assembly at the front of the unit.
Chapter 3. Removing and installing BladeCenter T modules and options
33