IBM BladeCenter T 8720 Installation And User Manual page 37

7. Install the bezel assembly on the front of the BladeCenter T unit by inserting the
bottom bezel hooks into the bezel slots at the bottom of the BladeCenter T unit.
Push in the bottom and the top of the bezel assembly until they both lock firmly
into place.
Notes:
1. Within 2 minutes after power has been connected to the BladeCenter T unit, the
management module applies power to the I/O modules.
2. If a power failure occurs, the BladeCenter T unit restarts automatically when
power is restored.
3. The blade-server power button turns on or turns off the blade server if local
power control has not been disabled through the management module.
4. The blade-server power button turns on the blade server only if the green power
light on the blade server is flashing slowly. If the light flashes rapidly, the blade
server has not yet synchronized with the management module, and pressing the
power button will have no effect. See Chapter 4, "BladeCenter T components,
controls, and LEDs," on page 51 for more information about the controls and
indicators on the BladeCenter T unit modules.
See the Installation and User's Guide for your blade server on the IBM BladeCenter
T Documentation CD for the location of the blade server LEDs.
Chapter 2. Setting up the BladeCenter T hardware
23