Bmf - AMX MVP-8400ii Operation/Reference Manual

"^" Button Commands (Cont.)

^BMF

Set any/all button
parameters by
sending 
embedded codes
and data.
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
Syntax:
"'^BMF-<vt addr range>,<button states range>,<data>'"
Variables:
variable text address char array = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
level range = 1 - 600 (level value is 1 - 65535).
data:
'%R<left>, <top>, <right>, <bottom>' = Set rectangle.
'%B<border style>' = Set the border style name. See theBorder Styles and Programming
Numbers table on page 104.
'%B',<border 0-27,40,41> = Set the borer style number. See theBorder Styles and
Programming Numbers table on page 104.
'%DO<1-5><1-5><1-5><1-5><1-5> = Set the draw order. Listed from bottom to top.
Refer to the ^BDO command on page 108 for more information.
'%F',<font 1-8,10,11,20-29,32-xx> = Set the font. See theDefault Font Styles and ID
Numbers table on page 103.
'%F<font 01-08,10,11,20-29,32-xx>' = Set the font. See theDefault Font Styles and ID
Numbers table on page 103.
'%MI<mask image>' = Set the mask image. Refer to the ^BMI command on page 113 for
more information.
'%T<text >' = Set the text using ASCII characters (empty is clear).
'%R = Sets button location and also resizes the button. Takes four parameters: left, top,
right, bottom.
'%P<bitmap>' = Set the picture/bitmap filename (empty is clear).
'%I',<icon 01-9900, 0-clear>' = Set the icon using values of 01 - 9900 (icon numbers are
assigned in the TPDesign4 Resource Manager tab - Slots section).
'%I<icon 01-9900, 0-clear>' = Set the icon using values of 01 - 9900 (icon numbers are
assigned in the TPDesign4 Resource Manager tab - Slots section).
'%J',<alignment of text 1-9> = As shown the following telephone keypad alignment
chart:
0
1 2 3
Zero can be used for an absolute position
4 6
5
7 8 9
'%JT<alignment of text 0-9>' = As shown the above telephone keypad alignment chart,
BUT the 0 (zero) is absolute and followed by ',<left>,<top>'
'%JB<alignment of bitmap/picture 0-9>' = As shown the above telephone keypad
alignment chart BUT the 0 (zero) is absolute and followed by ',<left>,<top>'
'%JI<alignment of icon 0-9>' = As shown the above telephone keypad alignment chart,
BUT the 0 (zero) is absolute and followed by ',<left>,<top>'
Programming
111