Ignition Controlled Locks; Auto Relock; Ignition / Accessory Upon Unlock; Oem Remote Arm/Disarm Update For 2 Way Firstech Remote - Firstech CM7200 Master Manual

CM7200 Master Guide
1-09 Ignition Controlled Locks: When FO 2-4 are selected, the user can activate the "drive lock" or ignition
controlled door locking feature using a Firstech remote or Drone. (Please check specific remote
user's manual for steps to activate Drive lock.)
FO1 - Off: (default)
FO2 - On: This option (when activated with the Firstech remote or Drone) will provide a door lock
output when the foot brake is applied or 12 Volts is applied to the foot brake input on the CM7. The
CM7 will also provide a door unlock output as soon as the key is turned off or 12v ignition is removed
from the CM7.
FO3 - RPM locking: (Tach input is required for this option to operate properly.) This
option will provide a door lock output at approximately 20% RPM over the programmed idle tach
output. (i.e. program tach at 1000 rpm and doors will lock at a sustained 1200 rpm when moving.)
The CM7 will also provide a door unlock output as soon as the key is turned off or 12v ignition is
removed from the CM7.

1-10 Auto Relock:

FO1 - Off: (default)
FO2 - 30 seconds: This option allows the CM7 to automatically relock/rearm 30 seconds after
CM7 has been disarmed/unlocked. This will only happen if no zones have not been opened.
FO3 - 60 seconds: This option allows the CM7 to automatically relock/rearm 60 seconds after
CM7 has been disarmed/unlocked. This will only happen if no zones have not been opened.
FO4 - 5 minutes: This option allows the CM7 to automatically relock/rearm 5 minutes after it has
been disarmed/unlocked. This will only happen if no zones have not been opened.

1-11 Ignition / Accessory Upon Unlock:

FO1 - Off: (default)
FO2 - Ignition (+) and (-) pulse output with disarm: This option will pulse both (+) and
(-) ignition wires upon unlock/disarm. Most new Ford vehicles require ignition pulsed +
immobilizer with unlock to disarm the factory alarm.
FO3 - Accessory (+) and (-) pulse output with disarm: This option will pulse both (+) and
(-) accessory wires upon unlock/disarm.
FO4 - Ignition (+) and (-) pulse and Accessory (+) and (-) pulse output with disarm:
This option will pulse both (+) and (-) ignition and accessory wires upon unlock/disarm. Some new
Ford vehicles require ignition and accessory pulsed + immobilizer with unlock to
disarm the factory alarm. Important: Also used in cases where the vehicle's radio may turn on
and stay on until the door is opened when accessory is pulsed.
1-12 OEM Remote Arm/Disarm Update for 2 Way Firstech Remotes: This feature disables the arming,
disarming, and remote start confirmation updates to any Firstech 2 Way LCD when using an OEM
remote.
FO1 - On: (default)
FO2 - Off: This feature disables the page back update to the 2 Way Firstech remote when your
interface module provides OEM remote status updates to the CM7.
Copyright 2014 Firstech, LLC. Copyright 2014 Firstech, LLC. Copyright 2014 Firstech, LLC.
Starter System
techfeed.compustar.com
Page 31 Page 3 Page 3