Da-Lite Ascender Electrol Instruction Book
  1. Manuals
  2. Brands
  3. Da-Lite Manuals
  4. Projection Screen
  5. Ascender Electrol
  6. Instruction book

Da-Lite Ascender Electrol Instruction Book

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTION BOOK FOR
Ascender Electrol

Advertisement

Table of Contents
loading

Related Manuals for Da-Lite Ascender Electrol

Summary of Contents for Da-Lite Ascender Electrol

  • Page 1 INSTRUCTION BOOK FOR Ascender Electrol...

  • Page 2: Important Safety Instructions

    Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: Read and understand all instructions before using. 4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized service dealer when repair 2.
  • Page 3 4. Test the screen by running it up and down a few times. Be prepared to stop the screen if needed. Ascender Electrol® Installation For installations where the Ascender will be set on the floor, the 2. For installations where the Ascender will be recessed into the...

  • Page 4: Low Voltage Connections

    Ascender Electrol® Installation WARNING: To prevent electrical shock or damage to the low voltage control (LVC), do not apply power to the LVC until all connections are complete. Make sure power is turned off on all wires before making connections.
  • Page 5 Ascender Electrol® Installation Single Pull, Single Throw 120V Wiring Diagram Momentary Contact Switch White (Common) Up / Stop / Down Green (Ground) Optional IR Or RF Black (Up) Connection Red (Down) Black White (Common) White (Common) Black (Hot) White (Common)

  • Page 6: Screen Adjustment

    Screen Adjustment The screen stop positions are preset at the factory. Should it be necessary to adjust for more or less travel proceed as follows (Figure 4). To Increase Screen Height To Adjust The Down Position Turn the white limit adjuster counterclockwise one-quarter turn Raise the screen about one foot and stop.

  • Page 7: Troubleshooting

    Troubleshooting Symptom Cause Solution Tripped circuit breaker. Reset circuit breaker. Check above. Tighten all loose wire connections. Correct any improper connections. Screen will not operate or will No power to operating switch or junction. not go “down”. “Down” Position. Motor does not hum. Check for power across black and white leads.
  • Page 8 OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137, Warsaw, IN 46581-0137, (574) 267-8101, (800) 622-3737.

Table of Contents