Advertisement
È
LT
2
1
É
LT
2
STEERING SYSTEM/LUBRICATION
LT
2
1
LT
1
2
3. Adjust:
• Ski toe-out
Adjustment steps:
• Loosen the locknuts (tie-rods) 1.
• Turn the tie rods 2 in or out until the specified
toe-out is obtained.
• Tighten the locknuts (tie-rods) 1.
Tie-rod end locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
LOCTITE
CAUTION:
After tightening the inside and outside ball joint
locknuts 1, make sure the tie rods 2 can be
rotated freely through the ball joint travel. If not,
loosen the locknuts 1 and reposition the ball
joint so that the tie rods 2 can be rotated freely.
Tighten the locknuts to specification.
È Outside
É Inside
LUBRICATION
Brake lever, throttle lever and throttle cable end
1. Lubricate the brake lever pivot, throttle lever and
the ends of the throttle cables.
Recommended lubricant:
ESSO Beacon 325 Grease or
Aeroshell Grease #7A
WARNING
Apply a dab of grease onto only the end of the
cables.
Do not grease the throttle cables.
They could freeze and cause a loss of control.
2-41
INSP
ADJ
®
Advertisement
Chapters
