I Set Mode Programming - Icom IC-M601 Instruction Manual

I Set mode programming

Set mode is used to change the condition of the transceiver's
functions and the microphone's own functions:
Transceiver's functions—
scan type (normal or priority), scan resume timer, dual-
watch/tri-watch of COMMANDMIC, transceiver's beep tone,
internal speaker (transceiver), LCD contrast (transceiver) and
foghorn frequency.
Microphone's own functions—
beep tone function (microphone) and LCD contrast (micro-
phone).
In this section, instructions are for the microphone's own func-
tions only. Refer to pgs. 37–39 for the setting of the other
functions. (Some functions may not be selectable from the mi-
crophone.)
ï ï Entering set mode
q Turn power OFF.
w While pushing and holding [16•C], turn power ON.
• After beep emission, a set mode item (in the channel comment
indicator and condition in the channel number readout) is dis-
played.
e Push [16•C] to select the desired item, if necessary.
r Push [Y]/[Z] to select the desired condition of the item.
t Turn power OFF, then ON to exit set mode.
HM-134 REMOTE-CONTROL MICROPHONE
• Beep tone "BEEP"
➥ Push [Y] to turn ON, [Z] to turn OFF the beep output.
• LCD contrast "LCD CONTRAST"
➥ Push [Y]/[Z] to adjust to a suitable LCD contrast.
• Internal speaker "INT-SPEAKER"
➥ Push [Y]/[Z] to turn the HM-134 internal-speaker ON/OFF.
Push
• •
Push
• •
Push
13
13
57