Table of Contents
Advertisement
For Wireless Network Users
h
Press
or
Encryption Type? and press OK.
Enter the Pre-Shared Key (WPA/WPA2-PSK)
password you wrote down in step 17 on
page 30 using the dial pad to choose each
letter or number.
For example, to enter the letter a, press the 2
key on the dial pad once. To enter the number
3, press the 3 key on the dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
(For more information, see Entering Text for
Wireless Settings on page 44.)
Press OK when you have entered all the
characters, then press 1 for Yes to apply your
settings. Go to step k.
i
Enter the user name and press OK. You can
use
or
to move the cursor. For example,
to enter the letter a, press the 2 key on the dial
pad once.
Enter the password and press OK, and then
press 1 to apply your settings. Go to step k.
(For more information, see Entering Text for
Wireless Settings on page 44.)
j
Press
or
Encryption Type? and press OK.
Enter the user name and press OK. You can
use
or
to move the cursor. For example,
to enter the letter a, press the 2 key on the dial
pad once.
Enter the password and press OK, and then
press 1 to apply your settings. Go to step k.
(For more information, see Entering Text for
Wireless Settings on page 44.)
k
Your machine will now try to connect to your
wireless network using the information you
have entered. If successful, Connected will
appear briefly on the LCD.
If your machine does not successfully connect
to your network, verify your network settings
collected in step 17 on page 30, then repeat
steps a to j to make sure you have entered the
correct information.
If your access point does not have DHCP
enabled you will need to manually configure
the IP address, subnet mask and gateway of
the machine to suit your network. See the
Network User's Guide for details.
32
to choose TKIP or AES for
to choose TKIP or AES for
Wireless setup is now complete. A four
level indicator at the top of your
machine's LCD will show the wireless
signal strength of your access point or
router.
To install Multi-Function Suite or Océ,
continue to step 19.
®
For Windows
Users:
Now go to
page 35
For Macintosh Users:
Now go to
page 39
Advertisement
Table of Contents
