Panasonic AJ-PX800G Operating Instructions Manual page 149

[SET02:MON/HDMI FORMAT]
Sets the formats of video output from the <MON OUT> and <HDMI> terminals.
Corresponding button
<%/REW> button
<STOP> button
[SET03:MON/HDMI SETUP]
Sets the output setting of the <MON OUT> terminal and <HDMI> terminal.
Corresponding button
<%/REW> button
<STOP> button
<FF/)> button
[SET04:LCD]
Sets the display settings of SmartUI.
Corresponding button
<FF/)> button
<PLAY/PAUSE> button
<RESET> button
Chapter 7 SmartUI operation — SmartUI menu list
[MON]
Sets the signal format type output from the <MON OUT>
terminal.
With this setting, the signal format to be output from the
<HDMI> terminal is also switched.
[D.CON]
Sets the aspect for the down-conversion output signal in the
HD mode. This item is not displayed in the SD mode.
[OUT]
Sets whether to output from the <MON OUT> terminal.
[CHR]
Specifies whether characters are superimposed over the output
from <MON OUT>, <HDMI>, and <REMOTE> terminals.
This setting is disabled when a remote control unit (AG-EC4G) is connected, and the settings on the remote control unit or
extension control unit supersede.
[ZBR]
Specifies whether the zebra pattern is superimposed over the
output from <MON OUT>, <HDMI>, and <REMOTE> terminals.
f This setting is not available when the setting menu on the
viewfinder is open.
[−]
Decreases the setting value of the selected item. Press and hold this button to continuously decrease the setting value.
[+]
Increases the setting value of the selected item. Press and hold this button to continuously increase the setting value.
[RST]
Resets the setting value of the selected item to its factory setting value.
Setting details and setting value
[AUTO] (HDMI: [1080i/720P])
Displayed only in the HD mode.
Outputs the SDI signal according to main menu → [SYSTEM
MODE] → [LINE&FREQ] setting.
f The 1080i or 720P signal is also output from the <HDMI>
terminal according to the [LINE&FREQ] setting.
f For [1080-23.98PsF], the signal pulled down to 1080/59.94i
is output from both <MON OUT> and <HDMI> terminals.
[480i] or [576i] (HDMI: [480P] or [576P])
Displayed only in the HD mode.
The SDI signal of 480i or 576i is output.
f The 480P or 576P signal is output from the <HDMI> terminal.
[SDI] (HDMI: [480P] or [576P])
Displayed only in the SD mode.
Outputs the SDI signal for 480i or 576i according to main menu
→ [SYSTEM MODE] → [LINE&FREQ] setting.
f The 480P or 576P signal is output from the <HDMI> terminal.
[VBS] (HDMI: [480P] or [576P])
A composite video signal is output.
f The 480P or 576P signal is output from the <HDMI> terminal.
[CROP]
Side-crop mode (Crops the left and right edges.)
[L.BOX]
Letterbox mode (Adds black bands at the top and bottom of
the image.)
[SQU]
Squeeze mode (Squeezes images horizontally.)
Setting details and setting value
[ON], [OFF]
[ON], [OFF]
[ON], [OFF]
Setting details and setting value
– 149 –
indicates factory setting values.
indicates factory setting values.
indicates factory setting values.