Gemini 4:4:4 User Manual page 70

In which:
st
• The 1 8 characters are provided by the C500 (to match the camera's internal recording clip name)
• The next 7 characters following "_" are the frame counter digits.
• ".RMF" is the Canon Raw-specific file extension.
7. SSD Smart Status:
Detailed SSD information such as expected SSD life is now available in the SSD information popup
(accessible by pressing "SSD Info" tab and then pressing the SSD percent filled bar ).
8. Expanded Tally Function: Green for "Record Ready", Red for "Recording"
Record Tally option in the menu (Outputs->Rec Tally):
When activated, this option is now expanded to include a "Green Tally Bar" indicator on the outputs when
the Gemini Recorder is in a Record Ready state. And then as before, with this option activated while
Recording, a "Red Tally Bar" is placed at the bottom of the monitor outputs.
Bug Fixes, Version 1.5.146

From Canon C500, 4K Raw, fixed a bug in which the recorded data on the Gemini Recorder would
on rare occasions have a random set of 5 pixels in a given frame which would be shifted a single
pixel to the left or right. This tiny error in the video data was not visible or at worst barely visible to
the naked eye. This has been fixed.

Fixed a WAV audio issue that caused WAV files to not import.
Known Bugs, Version 1.5.146

On rare occasions, when playing back recorded footage within the Gemini Recorder: the display
will roll or shift the video and play in an odd fashion. The recorded video, however, is not effected
and remains intact. Stopping and restarting Play fixes the display and outputs.

On rare occasions, timecode can repeat from 1 frame to the next, and then is corrected thereafter.

When recording Canon Raw Quad HD, after a Record session has ended the display on the Gemini
Recorder will go black momentarily. This does not effect the recorded data or the functioning of
the unit whatsoever.

The message "Video Input Stream Errors, Check Cables" will normally appear when the Gemini
Recorder sees errors in the incoming data stream, and may indicate insufficient cabling. However,
sometimes this error message will inadvertently appear when changing video formats on the
camera (especially the Canon C500). In such cases the message can be ignored.

When attempting to set up a 1080p50 or 1080p59.94 RGB 4:4:4 input to the Gemini Recorder: if
Dual-Link is required, the Gemini may not indicate this. The Gemini may show a single-Link as a
valid 1080p25 or 1080p29.97 input.

In this case, connect the 2

When switching the Canon C500 from 2K to 1080p, the Gemini Recorder may not properly detect
the input change. In this case pull and re-insert the input cable for the Gemini to get an accurate
reading of the input.
www.Gemini444.com
Gemini 4:4:4 User Manual
nd
link to achieve the desired 1080p50/59.94 input.
021313
69 | P a g e