Table of Contents
Advertisement
POWER
There are multiple ways to power your Gemini 4:4:4;
1. Using the provided AC Power Supply which includes international power plugs
2. Using 4-Pin XLR Power, using the supplied 4-Pin XLR to 4-Pin Hirose Power Cable.
3. Using an Anton Bauer or IDX Battery with a D-Tap connection. A D-Tap to 4-Pin Hirose Power
Cable is included.
4. Using any 4-Pin Hirose Power cable as provided by Convergent Design for Gemini 4:4:4 or
nanoFlash.
5. Using any suitable DC power source, 6 to 19 Volts DC, with a 4-Pin Hirose connector.
Power Supply must supply at least 20W.
WARNING! POWER INPUT IS LIMITED TO 6-19 VOLT DC.
Please check the voltage and polarity before using.
DC Converter (ARRI users) or the Power Protection Module from your local Dealer.
AC Power Supply
Simply connect the 4-pin Hirose to 4-Pin Male XLR
cable to the Female 4-Pin XLR connector on the AC
Power Supply and plug into a suitable AC power
source.
Gently turn to fit and click the Hirose connector into
the Power 6-19V connector on the left of the Gemini
4:4:4.
Do not force the power connector into the Remote
Tally connector on the right side of the Gemini
4:4:4.
Camera
Using the supplied HD-SDI cables, or other high quality True 75 Ohm HD-SDI cables with True 75
Ohm connectors, connect your camera to SDI A, or to both SDI A and SDI B (for Dual Link).
Use of 50 Ohm and/or low quality cables will cause the video signal to be intermittent.
In the event of power loss during record, the Gemini will automatically attempt to recover the
last recorded clip (when power is restored and assuming that the same SSD's are inserted).
www.Gemini444.com
Pin 1 & 2 Must be Positive DC Voltage
Pin 3 & 4 Must be Negative or Ground
Gemini 4:4:4 User Manual
You may also purchase our DC –
021313
20 |
P a g e
Advertisement
Table of Contents
