Advertisement
OPERATION
BEFORE ATTACHING OR REMOVING ANY ACCESSORIES BE SURE TO
DISCONNECT THE DEMOLITION BREAKER FROM THE POWER SUPPLY
Front Handle
The front handle will provide additional control, support and guidance for the
tool. The handle is adjustable to any position around the 360º handle collar
mount. The handle will come assembled to the tool yet the locking knob will
need to be fastened to secure the handle in place. Loosen the handle by
rotating the locking knob anti clockwise. Adjust the front handle to the
desired position and retighten by turning the locking knob clockwise.
Fitting the Dust Cover
The dust cap prevents dust and debris generated while using the demolition
breaker from entering the bit lock and gear box. To fit the dust cover, remove
any accessory, place the large opening of the dust cover over the bit lock
and align the hole with "LOCK, UNLOCK" text over the bit lock knob. Insert
the accessory bit through the hole in the dust cover and back into tool
holder as described in the "Fitting Accessories" section below. This should
be a tight fit and will require force to push the hex part of the accessory
through the dust cover hole.
Note: The dust cap MUST always be fitted, and the dust cap MUST be
replaced when worn to maintain the working life of the machine. Failure
to do so will void the warranty.
Fitting and Removing Accessories
1. Clean and grease the
accessories shank.
2. Pull out the bit lock
and rotate it 180°.
3. Insert the shank of the
accessory through hole
in the dust cover into the nose of the tool. Ensure the notch in the shank
is positioned as per illustration shown on the right. Should the notch be
in the incorrect position the shank will not lock into position.
7
Advertisement
