Table of Contents
Advertisement
Electrical Requirements
Electrical Requirements
• Viking Range Corporation will NOT
This product is manufactured with the
neutral terminal connected to the cabinet.
Use a 3-wire, agency approved, power
supply kit with closed loop terminals rated
If the use of a GFI is required, it should be:
per the National Electrical Code, ANSI/NFPA
• Of the receptacle type (breaker type or
70-latest edition (See Rating chart below). If
local codes prohibit grounding through the
• Used with permanent wiring only
neutral, use a 4-wire, agency approved,
power supply kit with closed loop terminals
rated per the National Electrical Code,
• On a dedicated circuit (no other
ANSI/NFPA 70-latest edition (See Rating
chart below).
• Connected to a standard breaker of
RATING*
Specified Rating of Power
Supply Cord Kit and Circuit Protection
120/240 Volts
120/208 Volts
Amps
• Rated for Class A (5 mA +/- 1 mA trip
12.5 - 16.5 KW
9.2 - 12.5 KW
40 or 50
16.5 - 17.5 KW
12.5 - 13.5 KW
50
• In good condition and free from any
*The National Electric Code calculation for
Electrical Load is less than the Total
Connected Electrical Load listed on the
• Protected from moisture (water, steam,
model/serial rating plate.
A GFI shall be used if required by NFP -
70 (National Electric Code),
federal/state/local laws, or local
ordinances.
• The required use of a GFI is normally
related to the location of a receptacle with
respect to any significant sources of water
or moisture.
Electric 30"
Range
Electrical
connection
in this area
6"
(15.2 cm)
4-3/8"
(11.1 cm)
10
warranty any problems resulting from GFI
outlets which are not installed properly or
do not meet the requirements below.
portable type NOT recommended)
(temporary or portable wiring NOT
recommended)
receptacles, switches or loads in the
circuit)
appropriate size (GFI breaker of the same
size NOT recommended)
current) as per UL 943 standard
loose-fitting gaskets (if applicable in
outdoor situations)
high humidity) as much as reasonably
possible
WARNING
Electrical shock hazard.
To avoid the risk of electrical
shock, personal injury or death;
verify electrical power is turned
off at the breaker box until the range is
installed and ready to operate, installation
by an authorized installer only.
6"
(15.2 cm)
General Information
READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION WHEN
Moving, Handling, and Unpacking
INSTALLING THIS APPLIANCE.
Remove and discard all packing materials,
including cardboard and tape on the outside
• All openings in the wall behind the
and inside of the range.
appliance and in the floor under the
appliance must be sealed.
Range – Do not discard the anti-tip
metal bracket supplied with the
• DO NOT obstruct the flow of combustion
range. This is the anti-tip device and
and ventilation air.
must be installed with the unit. Refer
to "Anti-tip Device Installation"
CAUTION
section.
Avoid any damage to oven vents. The vents
need to be unobstructed and open to provide
Some stainless steel parts may have a plastic
proper airflow for optimal oven performance.
protective wrap which must be peeled off.
The interior should be washed thoroughly
with hot, soapy water to remove film
CAUTION
residues and any dust or debris before being
The cooling fan should be operating when
used, then rinsed and wiped dry. Solutions
the unit is in operation. If you notice the
stronger than soap and water are rarely
cooling fan is not operating or you observe
needed.
unusual or excessive noise coming from the
cooling fan, contact a Viking Authorized
Service Center before continuing operation.
Failure to do so can result in damage to the
oven or surrounding cabinets.
11
Advertisement
Table of Contents
