Table of Contents
Advertisement
Final Preparation
• All stainless steel body parts should be
wiped with hot, soapy water and with a
liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool,
abrasive cloths, cleansers, or powders!
If it is necessary to scrape stainless steel
Performance Checklist
A qualified installer should carry out the
h Check self-clean function—door will lock
following checks:
h Check top surface elements—glow red
when turned on.
h Check hot surface indicator lights—glow
red when corresponding element is on.
h Check oven bake function—bake element
on full power, center and outside broil
elements at partial power.
h Convection bake function—bake and broil
elements the same with the convection fan
on.
h Check TruConvec™ function—TruConvec
element (behind convection fan cover) on
and convection fan on.
h Check HI broil function–both broil
elements at full power.
h Check LOW broil function—inner broil
element only.
h Check convection broil function—both
broil elements at full power with convection
fan on.
22
to remove encrusted materials, soak with
hot, wet cloths to loosen the material, then
use a wool or nylon scraper. DO NOT use
a metal knife, spatula, or any other
material tool to scrape stainless steel!
Scratches are almost impossible to
remove.
in approximately 30 seconds, the center
and outside broil elements will turn on and
the bake element will turn on at partial
power. Check broil elements through
window to make sure they are on, then
abort self-clean cycle to unlock door.
NOTICE
When conducting performance test,
DO NOT run self-clean cycle for more
than 10 minutes with oven racks inside
oven. This could cause them to discolor
due to the high temperature required
for self-cleaning.
Service & Registration
Only authorized replacement parts may be used in performing service on the appliance.
All servicing should be referred to a qualified technician.
Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts
distributor in your area or write to:
VIKING RANGE CORPORATION
PREFERRED SERVICE
1803 Hwy 82W
Greenwood, Mississippi 38930 USA
Range – The serial number and model number for your appliance can be
found by opening the door and looking under the control panel.
Record the following information indicated below. You will need it if
service is ever required.
Model number
____________________________________________________________________________________
Serial number
_____________________________________________________________________________________
Date of purchase
__________________________________________________________________________________
Date installed
______________________________________________________________________________________
Dealer's name
_____________________________________________________________________________________
Address
___________________________________________________________________________________________
These installation instructions should remain with the unit for future reference.
23
Advertisement
Table of Contents
