Important: Please Read And Follow; General Information; Electrical Grounding Instructions - Viking Range 30” W. Models Installation Manual

IMPORTANT:
PLEASE READ AND FOLLOW
• Before beginning, please read these instructions
completely and carefully.
• Do not remove permanently affixed labels, warnings, or
plates from the product. This may void the warranty.
• Please observe all local and national codes and
ordinances.
• Please ensure that this product is properly grounded.
• The installer should leave these instructions with the
consumer who should retain for local inspector's use and
for future reference.
Installation must conform with local codes or, in the
absence of codes, the National Fuel Gas Code, ANSI
Z223.1 or the latest edition. IN CANADA: Installation
must be in accordance with the current CAN/CGA B149.1
& 2 Gas Installation codes and/or local codes. Electrical
installation must be in accordance with the current CSA
C22.1 Canadian Electrical Codes Part 1 and/or local codes.
Installation of any gas-fired equipment should be made by
a licensed plumber. A manual gas shut-off valve must be
installed in the gas supply line ahead of the oven in the gas
stream for safety and ease of service.
In Massachusetts: All gas products must be installed by a
"Massachusetts" licensed plumber or gasfitter. A "T"
handle type manual valve must be installed in the gas
supply line to the appliance
WARNING
•This range can tip.
•Injury to persons could result.
•Install anti-tip device packed with range.
•See Installation Instructions
WARNING
IF THE INFORMATION IN THIS MANUAL IS
NOT FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY, OR DEATH.
1. Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
2. WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use
any phone in your building.
•Immediately call your gas supplier from a
neighbor's phone.
•Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire
department.
3. Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
WARNING
If not installed, operated and maintained in
accordance with the manufacturer's instructions,
this product could expose you to substances in fuel
or from fuel combustion which can cause death or
serious illness and which are known to cause
cancer, birth defects, or other reproductive harm.
For example, benzene is a chemical which is
part of the gas supplied to the cooking
product. It is consumed in the flame during
combustion. However exposure to a small
amount of benzene is possible if a gas leak
occurs. Formaldehyde and soot are by-
products of incomplete combustion. Properly
adjusted burners with a bluish rather than
yellow flame will minimize incomplete
combustion.
2

GENERAL INFORMATION

•WARNING: The use of cabinets for storage above the
appliance may result in a potential burn hazard.
Combustible items may ignite, metallic items may become
hot and cause burns. If a cabinet storage is to be provided
the risk can be reduced by installing a rangehood that
projects horizontally a minimum of 5" (12.7 cm) beyond the
bottom of the cabinets.
•WARNING: This appliance shall not be used for space
heating. This information is based on safety
considerations.
•All openings in the wall behind the appliance and in the
floor under the appliance shall be sealed.
•Keep appliance area clear and free from combustible
materials, gasoline, and other flammable vapors.
•Do not obstruct the flow of combustion and ventilation air.
•Disconnect the electrical supply to the appliance before
servicing. The power disconnect for the sealed top
units is located behind the lower access panel of the
range. This should only be removed by a qualified
service technician.
•When removing oven for cleaning and/or service;
A. Shut off gas at main supply
B. Disconnect AC power supply
C. Disconnect gas line to the inlet pipe.
D. Carefully remove the range by pulling outward.
•Electrical Requirement
Listed on Specification sheet. Electrical installation should
comply with national and local codes.
•Gas Manifold Pressure:
Natural gas 5.0" W.C.P.
LP/Propane 10.0" W.C.P.
•Flexible Connections:
If this unit is to be installed with flexible couplings and/or
quick disconnect fittings, the installer must use a flexible
connector of at least 1/2" ID (1.3 cm) NPT with suitable
strain reliefs and comply with ANSI Z21.41 and Z21.69
standards.
•The misuse of oven doors (e.g. stepping, sitting, or leaning
on them) can result in potential hazards and/or injuries.
LEGS
•Legs are packed in styrofoam top pack.
•Legs should be installed near to where the appliance is to
be used, as they are not secure for long transit. After
unpacking the range, raise it about a foot to remove the
bottom shipping skid. Keep the unit raised to permit the
legs to be screwed into our couplings and lower it gently
to keep any undue strain from the legs and internal
mounting hardware. It is strongly recommended that a
pallete or lift jack be used rather than tilting.
NOTE: If legs are removed from range and range rests on a
combustible surface, warranty and AGA/CGA
certification are void.
WARNING

ELECTRICAL GROUNDING INSTRUCTIONS

This range must be electrically grounded in
accordance with local codes, or in the absence of
local codes, with the National Electrical Codes,
ANSI/NFPA 70-latest edition. This appliance is
equipped with a three-prong plug for your
protection against shock hazard and should be
plugged directly into a properly grounded
receptacle. Do not cut or remove the grounding
prong from this plug. Do not connect product to
GFI circuit. The minimum of 102VAC is required for
proper operation of gas ignition systems. Prior to
servicing, disconnect appliance electrical supply.
For sealed top units the power disconnect is
located behind the lower access panel. This
should only be removed by a qualified service
technician.
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE PROPERLY GROUNDED
BACK TRIM ACCESSORIES
Assembly and installation instructions are included
with all back trim accessories.
3