Proximity To Side Cabinet Installation; Electrical Requirements - Viking Range 30” W Installation Instructions Manual

Proximity to Side Cabinet Installation

1. This range may be installed directly adjacent to existing 36" (91.4 cm) high base cabinets. IMPORTANT: The side
trim MUST be 3/8" (.95 cm) above the adjacent base cabinet countertop. This may be accomplished by raising the
unit using the adjustment spindles on the legs.
2. The range CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical
surfaces above 36" (91.4 cm) high. There must be a minimum of 6" (15.2 cm) side clearance from the range to such
combustible surfaces above the 36" (91.4 cm) counter height.
3. Within the 6" (15.2 cm) side clearance to combustible vertical surfaces above 36" (91.4 cm) , the maximum wall
cabinet depth must be 13" (33.0 cm) and wall cabinets within this 6" (15.2 cm) side clearance must be 18" (45.7 cm)
above the 36" (91.4 cm) high countertop.
4. Wall cabinets above the range must be a minimum of 42" (106.7 cm) above the range cooking surface for the full
width of the range. This minimum height requirement does not apply if a rangehood is installed over the cooking
surface.
36"
(91.4 cm)
*Overall Width

Electrical Requirements

Check your national and local codes regarding this unit. This range requires 3 wires, 240-208/120 VAC/60 Hz. See
next section for grounding instructions. It should be fused separately. CAUTION: Be sure the electrical power is off
from the breaker box to the junction box until the range is installed and ready to operate. The junction box should be
located as shown in the drawing and connected to a suitable ground.
42" Minimum
(106.7 cm)
6" Minimum
(15.2 cm)
0" (0.0 cm)
Adjustment
Spindles
30" W. Models
29 7/8" (75.9 cm)
13" Minimum
(33.0 cm)
3/8" (.95 cm)
36" W. Models
35 7/8" (91.1 cm)
6
0"
(0.0 cm) 18" Minimum
(45.7 cm)
48" W. Models
47 7/8" (121.6 cm)