Remote Surveillance - Elvox 46340.F04 Operation Manual

CCTV
Step 3: Select a required file or checkmark "All" to select all data files. Click Backup button to pop up Backup
information window.
Step 4: In the backup information interface, user can check the relevant options for backing up files. These options
include storage Media, backup player and save file type. Then click Start button to start backup.

10. Remote Surveillance

In order to view the DVR from a network it must be connected to a LAN/WAN or internet. The network setup should be
done accordingly.
10.1 Access DVR on LAN
Please enter into Menu Setup
● Input IP address, Subnet, Gateway. If using DHCP, please enable DHCP in both the DVR and the router. Enter into
Menu Information
● Enter into Record Setup to set network video parameters like resolution, frame rate etc.
● Open IE on a computer on the same network. Input the IP address of the DVR in IE address bar and press enter. If
HTTP port is not 80, add the port number after IP address.
● IE will download ActiveX component automatically. Enter the username and password in the subsequent window
10.2 Access DVR on WAN
1. Connect the DVR to internet through router or virtual server
Please enter into Menu Setup
● Input IP address, Subnet, Gateway. If using DHCP, please enable DHCP in both the DVR and the router.
● Forward IP address and port number in Virtual Server setup of the router or virtual server. Configure the firewall to
allow accessing the DVR. (If the user has enabled the UPnP function in both the DVR and router, he can skip this step.
Please refer to the relevant chapter for more details.)
● Open IE browser, input IP address, or dynamic domain name and enter. If HTTP port is not 80, add the port number
after IP address or domain name.
● IE will download ActiveX automatically. Then a window pops up and asks for user name and password. Input name
and password correctly, and enter to view.
2. Connect the DVR to Internet through PPPoE
● Enter into the DVR's Main Menu Setup Network interface to enable PPPoE and then input user name and
password received from your ISP. Next, click 'Apply'. The DVR will connect to the server and would give a confirmation
message.
● If users want to utilize dynamic domain name, please apply for a domain name in a DNS server supported by the
DVR or router. Then add to the DVR or router.
● When accessing the remote interface of DVR, user can input WAN IP/domain name to access directly (user can enter
into Main menu Information Network interface to check IP address). The browser will download Active X control
● The following steps are the same as the connection way above.
19
Network Setup as shown below:
Network, and user can check the network settings of the DVR.
Network Setup as shown above.
EN