Elvox 46340.F04 Operation Manual page 16

CCTV
7.3 Motion Based Recording
Motion detection based recording: when there is a motion event detected, the camera will be triggered to record.
To Setup Motion Based Recording:
Step 1: Enter into Menu Setup Schedule Motion tab. The setup steps for schedule for motion based recording are
similar to normal schedule setup. You can refer to 7.2 Schedule Recording for details.
Step 2: Enter into Menu Setup Alarm Motion Motion tab as shown below.
Step3: Enable motion alarm (Please specify to channel) and click 'Apply' to save settings.
Step4: Click 'Setting' button under the Area to set Sensitivity and Detection area. Left click the grid and drag to delete
the area. Drag again to add area. You can drag slide bar to set the sensitivity value (1-8). The higher the value is the
more sensitive it is to motion. Since the sensitivity is influenced by color and time (day or night), you can adjust its value
according to the practical conditions. Click
set detection area. Click
figure icon. Click icon to save the setting. Click
Step 5: Enter into Menu Setup Alarm Motion Schedule tab to bring up schedule settings for motion alarm. The
setup steps are similar to normal schedule setup. You can refer to 7.2 Schedule Recording for details.
Note: The timelines of the two schedules must match, otherwise you cannot get the record in some time.
7.4 Sensor Based Recording
To Setup sensor Based Recording:
Step 1: Enter into Menu Setup Schedule Sensor tab. The setup steps for schedule for sensor based recording are
similar to normal schedule setup. You can refer to 7.2 Schedule Recording for details.
Step 2: Enter into Menu Setup Alarm Sensor Basic tab, as shown below.
16
icon to set the whole area as detection area. Click
icon to test the sensitivity as per the local conditions. Once motion is sensed, it displays a
icon to exit the current interface
EN
icon to clear the