CCTV
3. Startup &Shutdown
3.1
Startup
Step1: Connect to cameras and monitor.
Step2: Connect with the source power;
Step3: The device will boot and the power indicator will display blue.
Step4: A WIZZARD window will be pop-up.
3.2
Shutdown
You can shut down the device by using IR remote controller and mouse.
By IR remote controller:
Step1: Press Power button. This will bring up a shutdown window. The unit will shut down by clicking "OK" button.
Step2: Disconnect the power
By mouse:
Step1: Enter into
Step2: Click OK. Then the unit will power off after a while.
Step3: Disconnect the power.
4. Setup Wizard
After the device starts, a setup wizard pops up. You can set up time,network , record and disk management.
Click Device name box to popup a keyboard as follows:
It supports digits, alphabets and symbols as inputs. Click Shift button to input Capital letters and symbols; click Shift
button again to return.
Click 'Next' button to bring up a network setup window.
The default HTTP port is 80. The default server port is 6036. You can check 'Obtain an IP address automatically' to
acquire network information or input IP address, subnet mask, gateway, preferred/alternate DNS server manually. This
function is used to monitor DVR through internet (See Section 10 for details).
13
Menu and select "Shut Down" icon. This will take you to a shutdown window.
EN