Single Unit Rapid Charger FOR IN-VEHICLE USE User Manual MODEL NCC0355...
Page 2
Introduction Thank you for purchasing an ENDURA™ NCC0355, Single Unit Rapid Charger. This high quality product is designed for charging LMR batteries in a ve hicle. With the appropriate charging pod installed, it can charge batteries with: Lithium ion (Li-Ion), nickel-metal hydride (NiMH), or nickel cadmium (NiCd) chemistry.
Page 3
6. Do not remove the charger’s housing or make any modification to the charger. 7. Use only the vehicle power adapter supplied with the NCC0355 charger. If a replacement is required, order part number TWC6-VPA. Use of other vehicle...
Page 4
Installing ENDURA NCC0355 1. Install NCC0355 in an area of the vehicle that is in close proximity to a 12V outlet. The location selected should allow the vehicle power adapter to be connected without excessive stretching of the cable. 2. Select a flat vertical surface in the vehicle for attaching the mounting bracket.
Page 5
Follow these steps to change the charging pod: 1. Obtain a charging pod made specifically for the NCC0355. Confirm that the charging pod is compatible with the battery you want to charge.
Page 6
Allow the charge status LED to go o be - fore placing another battery in the charging pod. 7. The NCC0355 is designed to operate at room temperatures between 15°C and 30°C. Charging batteries at temperatures outside this range may re sult in under charging of batteries.
Page 7
Fault Conditions When the charge status LED flashes RED, a fault condition exists. There are five di erent flash patterns, each indicating a specific type of fault. The flash patterns and fault conditions are as follows: LED Flash Pattern Fault Type Flashes 1 Indicates over-current condition caused by battery short Time...
Page 8
Warranty And Service During Warranty The ENDURA™ NCC0355 is made from high quality materials and designed to provide years of reliable service. The following warranty applies: Power Products Unlimited, Inc. (PPU) warrants this product to be free from defects in workmanship and materials for one-year from date of purchase by the end user.
Need help?
Do you have a question about the NCC0355 and is the answer not in the manual?
Questions and answers