Page 1
Single Unit Rapid Charger FOR RECHARGEABLE TWO-WAY RADIO BATTERIES Model: TWC1...
Page 2
Introduction Thank you for purchasing an ENDURA™ TWC1, Single Unit Rapid Charger. This high quality product is designed for charging two-way radio batteries. With the appropriate charging pod installed, it can charge these types of batteries: lithium ion (Li-Ion), lithium polymer (LiPo), nickel-metal hydride (NiMH), or nickel cadmium (NiCd).
Page 3
6. Do not remove the charger’s housing or make any modification to the charger. 7. Use only the power supply provided with the ENDURA™ TWC1 charger. If a replacement power supply is required, order part number TWC1-PS.
Page 4
Do not over tighten the screw. 5. Inspect the charging contacts to ensure they are clean and unobstructed. 6. Connect the power supply to the TWC1. You are now ready to charge a battery compatible with the charging pod.
Allow the charge status LED to go off before placing another battery in the charging pod. 9. The TWC1 is designed to operate at room temperatures between 15°C and 30°C (59° F – 86° F). Charging batteries at temperatures outside this range...
Page 6
Fault Conditions When the charge status LED flashes RED, a fault condition exists. There are three different flash patterns, each indicating a specific type of fault. The flash patterns and fault conditions are as follows: Flash Pattern Fault Type Flashes 1 Indicates charging complete, but battery is under charged.
Page 7
Warranty And Service During Warranty The ENDURA™ TWC1 is made from high quality materials and designed to provide years of reliable service. The following warranty applies: Power Products Unlimited, Inc. (PPU) warrants this product to be free from defects in workmanship and materials for one-year from date of purchase by the end user.
Need help?
Do you have a question about the TWC1 and is the answer not in the manual?
Questions and answers