Page 1
Single Unit Rapid Charger FOR RECHARGEABLE LMR BATTERIES Model: TWC1...
Page 2
Introduction Thank you for purchasing an ENDURA™ TWC1, Single Unit Rapid Charger. This high quality product is designed for use with rechargeable LMR batteries. With the appropriate charging pod installed, it can charge batteries with: Lithium ion (Li-Ion), nickel metal hydride (NiMH), or nickel cadmium ■...
Page 3
Do not remove the charger’s housing or make any modification to the charger. Use only the power supply provided with the ENDURA™ TWC1 charger. If a replacement power supply is required, order part number TWC1-C1. Use of other power supplies may damage the charger or batteries you may be attempting to charge.
Page 4
Do not over tighten the screw. Inspect the charging contacts to ensure they are clean and unobstructed. Connect the AC to DC power supply to the ENDURA™ TWC1. You are now ready to charge a battery compatible with the charging pod.
Page 5
Allow the charge status LED to go off before placing another battery in the charging pod. The ENDURA™ TWC1 is designed to operate at room temperatures be- tween 15°C and 30°C. Charging batteries at room temperatures outside...
Page 6
Indicates battery diagnostic has “timed out” and cannot be Times completed due to excessively low battery voltage. Charge battery with charger supplier with radio, then resume use of ENDURA™ TWC1. Flashes 3 Indicates over-heat condition for a Li-Ion battery. Battery Times temperature is over 43°C and charging has stopped.
Page 7
Warranty And Service During Warranty The ENDURA™ TWC1 is made from high quality materials and designed to provide years of reliable service. The following warranty applies: Power Products Unlimited, Inc. (PPU) warrants this product to be free from defects in workmanship and materials for one-year from date of purchase by the end user.
Need help?
Do you have a question about the TWC1 and is the answer not in the manual?
Questions and answers