Table 10: Account Settings - Grandstream Networks HT502 User Manual

Syslog Level
Select the HT502 to report the log level. Default is NONE. The level is one of DEBUG,
INFO, WARNING or ERROR. Syslog messages are sent based on the following events:
The Syslog uses USER facility. In addition to standard Syslog payload, it contains the
following components:
GS_LOG: [device MAC address][error code] error message
Example: May 19 02:40:38 192.168.1.14 GS_LOG: [00:0b:82:00:a1:be][000] Ethernet link
is up
Send SIP Log If Syslog is enabled and Send SIP Log is set to YES, then SIP messages will also be
delivered via Syslog. Default is set to NO.
Download Device
Allows user to download and save a text file containing all the P values of each setting as
Configuration configured at that point on the unit. (Note: For Security Reasons, all Passwords won't be
Downloaded)
Profile Active
Primary SIP Server
Failover SIP Server
Prefer Primary SIP
Server
Outbound Proxy
FIRMWARE VERSION 1.0.12.4
1. product model/version on boot up (INFO level)
2. NAT related info (INFO level)
3. sent or received SIP message (DEBUG level)
4. SIP message summary (INFO level)
5. inbound and outbound calls (INFO level)
6. registration status change (INFO level)
7. negotiated codec (INFO level)
8. Ethernet link up (INFO level)
9. SLIC chip exception (WARNING and ERROR levels)
10. memory exception (ERROR level)

TABLE 10: ACCOUNT SETTINGS

When set to Yes the FXS port is activated.
SIP Server's IP address or Domain name provided by VoIP service provider.
Failover SIP Server's IP address or Domain name in case primary server does not
respond.
Default is no. If set to yes it will register to Primary Server if registration with Failover
server expires
IP address or Domain name of Outbound Proxy, or Media Gateway, or Session Border
Controller. Used by HT502 for firewall or NAT penetration in different network
HT502 USER MANUAL Page 38 of 54