Register A Sip Account - Grandstream Networks HT801 User Manual

04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
 FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
 CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
 UPGRADE PROTOCOL
Select the menu option 15 to choose firmware and configuration upgrade protocol between TFTP, HTTP
and HTTPS.
 FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
"Always check, check when pre/suffix changes, and never upgrade".

Register a SIP Account

The HT801 supports 1 FXS port which can be configured with 1 SIP account. Please refer to the following
steps in order to register your account via web user interface.
1. Access your HT801 web UI by entering its IP address in your favorite browser.
2. Enter your admin password (default: admin) and press Login to access your settings.
3. Go to FXS Port page.
4. In FXS Port tab, set the following:
a. Account Active to Yes.
b. Primary SIP Server field with your SIP server IP address or FQDN.
c. Failover SIP Server with your Failover SIP Server IP address or FQDN. Leave empty if not
available.
d. Prefer Primary SIP Server to No or Yes depending on your configuration. Set to No if no Failover
SIP Server is defined. If "Yes", account will register to Primary SIP Server when failover
registration expires.
e. Outbound Proxy: Set your Outbound Proxy IP Address or FQDN. Leave empty if not available.
SIP User ID: User account information, provided by VoIP service provider (ITSP). Usually
f.
in the form of digit similar to phone number or actually a phone number.
g. Authenticate ID: SIP service subscriber's Authenticate ID used for authentication. Can be
identical to or different from SIP User ID.
h. Authenticate Password: SIP service subscriber's account password to register to SIP
server of ITSP. For security reasons, the password will field will be shown as empty.
Name: Any name to identify this specific user.
i.
5. Press Apply at the bottom of the page to save your configuration.
HT801 User Guide
P a g e | 20