Replacing The Controller Module - Rorke Data Galaxy Raid GALHDX-7370S-8U4D Installation And Hardware Reference Manual

Galaxy Raid GALHDX-7370S-8+12U4D Installation and Hardware Reference Manual
Step 5. Pull the controller module out: Once the retention screws have been

5.2.4 Replacing the Controller Module

Step 1. Remove the failed controller module. (See Section 5.2.3 above)
Step 2. Install a DIMM module on the new controller module. (See Section
Step 3. Insert the replacement controller. Align the controller module with
Step 5. Fasten the hand screws.
Step 6. Connect the controller module cables: Reconnect all of the cables
Step 7. Power on: Once the new controller module has been properly
5-4
Figure 5- 1: Loosen Controller Module Retention Screws
removed; gently pull the controller module out of the subsystem
chassis.
5.5)
the module bay at the rear of the subsystem.
controller module in.
completely inserted into the subsystem chassis, secure the controller
module to the chassis by tightening the hand screws at the sides of the
controller rear panel.
that were previously disconnected from the controller module. These
may include SCSI cables for host and expansion connections, an RS-
232C (audio jack) cable for serial port connection, and an Ethernet
cable for network connection.
installed and the cables have been correctly connected, turn the
subsystem power on.
Once the controller module has been
Replacing Controller Module Components
Gently slide the